The Divine HL38SVO 38" Outdoor See-Through Linear from Montigo
It divides the patio from the garden without closing either one off — and with no vent to route, it can stand where you want it. The Divine HL38SVO is a 38" outdoor-only see-through ventless gas fireplace with a linear burner and glass accessories: 45,000 BTU/hr on natural gas or propane - the highest output in the Divine line - a 41" x 38" x 23 7/8" framed opening in a fully non-combustible enclosure, from $8,639, covered by Montigo's residential fireplace warranty.
Choose it if you are dividing two outdoor areas and want one modern linear flame visible from both sides, with no venting to run. Your enclosure must be non-combustible top, bottom, and sides, and you need room for 12" side and 36" top clearances.
It is not right if you want it indoors or bridging an indoor and outdoor space (outdoor use only), if the enclosure would be wood-framed combustible construction, or if the location cannot absorb the large clearances - 12" sides, 36" top and header, 24" to a mantel, 48" to the ceiling.
Specifications
The framed opening is 41" wide x 38" high x 23 7/8" deep, back-framed a minimum of 38" on both sides. The enclosure's top, bottom, and sides must be non-combustible; steel studs with concrete, rock, or stone are acceptable, and the facing can exceed 350°F. Clearances: 36" top and header, 12" sides, 0" floor, 24" to a mantel, 48" to the ceiling. Gas supply: natural gas at 5.5" w.c. minimum inlet or propane at 11" w.c. Standing-pilot models need no electricity; E models use 110 V Honeywell Hot Surface Ignition. An optional stainless steel fan-assisted freestanding enclosure with heat-discharge vents is available.
| Series |
Divine Outdoor See-Through (ventless) |
| Fuel |
Natural gas (N suffix) or liquid propane (L suffix) |
| BTU input - NG |
45,000 BTU/hr |
| BTU input - LP |
45,000 BTU/hr |
| Venting |
Vent-free (ventless outdoor) - no vent pipe |
| Overall dimensions (unit) |
36 7/8" W x 36 1/2" H |
| Framing / enclosure opening |
41" W x 38" H x 23 7/8" D (non-combustible enclosure materials only) |
| Clearances (top / sides / floor) |
36" / 12" / 0" |
| Mantel / ceiling clearance |
24" / 48" |
| Standard media |
Contemporary linear burner with designer glass beads (HW1157) |
| Front |
Safety screen both sides |
| Flame control |
Manual Hi-Lo (front burners not adjustable) |
| Ignition |
Standing pilot or Honeywell hot surface ignition |
| Gas pressure - NG |
Min. inlet 5.5" W.C.; manifold 3.5" W.C. |
| Gas pressure - LP |
Min. inlet 11" W.C.; manifold 10" W.C. |
| Enclosure option |
Freestanding cool-touch stainless enclosure |
How the HL38SVO compares to the other Divine outdoor models
Same fireplace, traditional dress: the H38SVO (from $8,639) carries a logset instead of the linear burner. If you only need fire on one side of the wall, the single-sided outdoor line costs far less and keeps the linear look - the HL38VO runs a linear burner with firestones from $4,419 with much smaller clearances.
Answers to common questions
Can I install it indoors, or between an indoor and outdoor space?
No - it is for outdoor use only. It is a see-through divider for two outdoor areas, and the enclosure that houses it must be non-combustible on the top, bottom, and sides - steel studs faced with concrete, rock, or stone are acceptable. The facing can exceed 350°F in operation.
What does the enclosure have to be built from?
The framed opening is 41" W x 38" H x 23 7/8" D, back-framed a minimum of 38" on both sides, and the enclosure's top, bottom, and sides must be non-combustible (steel studs with concrete, rock, or stone are fine). Clearances are bigger than the single-sided outdoor models: 12" sides, 36" top and header, 24" to a mantel, 48" to the ceiling. Montigo also offers an optional stainless steel fan-assisted freestanding enclosure with heat-discharge vents, which carries its own clearance table.
What venting does it need?
None. This is an outdoor ventless see-through - no flue, no vent pipe, no chimney. Gas supply is the only rough-in: natural gas at 5.5" w.c. minimum inlet or propane at 11" w.c.
Does it need electricity? What happens in a power outage?
The standing-pilot versions (HL38SVON, HL38SVOL) use a SIT NOVA 820 millivolt system - no electricity needed. The E versions (HL38SVONE, HL38SVOLE) use Honeywell Hot Surface Ignition on a 110 V supply, with a remote switch in the wiring plan.
What fire media comes with it?
This is the contemporary model - Montigo classes it as 'Linear Burner w/Glass Accessories' in its model table. If you want a traditional logset instead, that is the H38SVO.
What’s included, what’s required, and what’s optional?
-
Included in the box: the burner with its supplied media, and the safety screen barrier (it must be installed).
-
Required to complete the installation, purchased separately: nothing — this is a ventless outdoor fireplace, so there is no flue, vent pipe or chimney to buy.
-
Optional: a drain pan, alternate media, and a remote.
Is it safe to buy a Montigo fireplace online? What about warranty?
Yes. The Torch Guys is 1 of only 3 authorized Montigo e-commerce dealers in the United States, so Montigo's residential fireplace warranty applies to your purchase, and we file warranty claims on your behalf if anything ever goes wrong. Want to talk it through first? Call (410) 324-6322.
Downloads
