The Divine H34VO 34" Outdoor from Montigo
No vent pipe, no chase, no roof penetration. Run gas to it and the fire goes wherever the seating is. The Divine H34VO is a 34" outdoor-only ventless gas fireplace with a five-log traditional set: 26,000 BTU/hr on natural gas or propane, a 27 1/4" x 18 1/4" viewing area, minimum framing of 35 3/8" W x 38 3/4" H x 20 1/4" D, from $3,869, covered by Montigo's residential fireplace warranty. No flue, no vent pipe.
Choose it if you want the fire built into the patio wall rather than sitting on it - no chimney, no vent run, nothing to route. Your design needs non-combustible facing and has to meet the outdoor siting rules (at least 2 open sides on a covered area, no recessing into the exterior wall).
It is not right if you want it indoors or in an enclosed space - ever (carbon monoxide hazard), if your covered patio has fewer than 2 open sides, if the surround will be combustible material (all facing must be non-combustible), or if you cannot plan a drain path for water management.
Specifications
Minimum framing is 35 3/8" wide x 38 3/4" high x 20 1/4" deep, measured to the back wall. Clearances: 9" top, 5 1/2" header, 1" sides, 0" floor, 1" back, 12" to a mantel, 36" to the ceiling, and a shelf must sit at least 9" above the top. All facing must be non-combustible. Gas supply: natural gas at 5.5" w.c. minimum inlet (3.5" manifold) or propane at 11" w.c. (10" manifold). Standing-pilot models need no electricity; E models use 110 V Honeywell Hot Surface Ignition.
| Series |
Divine Outdoor (single-sided, ventless) |
| Fuel |
Natural gas (N suffix) or liquid propane (L suffix) |
| BTU input - NG |
26,000 BTU/hr |
| BTU input - LP |
26,000 BTU/hr |
| Venting |
Vent-free (ventless outdoor) - no vent pipe |
| Overall dimensions (unit) |
33 7/8" front W x 24" back W x 33 1/4" H x 19 1/4" D |
| Viewing area |
18 1/4" x 27 1/4" |
| Framing |
33 7/8" front W x 33 7/8" back W x 38 3/4" H x 20 1/4" D (depth to back wall/studs) |
| Standard media |
Traditional logset |
| Front |
Safety screen (protrudes 2 3/8" from face); high-temperature front glass listed on spec sheet |
| Clearances (top / sides / back / floor) |
9" / 1" / 1" / 0" (sides and back measured to back wall or studs; 0" to insulation jacket) |
| Mantel / ceiling clearance |
12" / 36" |
| Clearance to grade |
12" (US; check local codes) |
| Flame control |
Manual Hi-Lo |
| Ignition |
Standing pilot (Robertshaw valve) or Honeywell hot surface ignition, depending on variant |
| Gas pressure - NG |
Min. inlet 5.5" W.C.; manifold 3.5" W.C. |
| Gas pressure - LP |
Min. inlet 11" W.C.; manifold 10" W.C. |
| Power vent / remote / fans / lighting |
Not available |
How the H34VO compares to the other Divine outdoor models
Need more fire? The 38" H38VO steps up to 34,000 BTU/hr and a 32 1/8" x 21 5/8" view from $4,419, and the 42" H42VO reaches 40,000 BTU/hr from $5,199. Prefer a modern linear flame over firestones instead of logs? The HL38VO runs from $4,419. For a two-sided outdoor divider, the see-through SVO models put out 45,000 BTU/hr from $8,639.
Answers to common questions
Can I install it indoors or in a screened room?
No - it is for outdoor use only. Running it in an enclosed space is a carbon monoxide hazard. Even outdoors there are siting rules: at least 2 sides of a covered patio or deck must be open, the unit may not be recessed into the exterior wall, and all fireplace facing must be non-combustible (the facing can exceed 250°F). Where the unit penetrates the building envelope or snow accumulates, keep 12" of clearance to grade unless a listed exception applies.
What venting does it need?
None. This is an outdoor ventless fireplace, so venting does not apply. No flue, no vent pipe, no chimney. That is a large part of the installed-cost saving over a direct-vent unit.
Does it need electricity? What happens in a power outage?
The standing-pilot versions (H34VON, H34VOL) are millivolt - the Honeywell valve powers itself, so no electricity is needed at all. The E versions (H34VONE, H34VOLE) use Honeywell Hot Surface Ignition on 110 V; outdoor wiring must sit in a water-tight electrical box with GFI protection per local code.
How do I handle rain and winter?
Plan a drain system - drainage planning is required for both in-wall and standalone installs, and Montigo offers an optional drain pan (OD34123) for this model. In freezing climates Montigo recommends an insulated chase with a vapour barrier.
What fire media comes with it?
Five ceramic-fibre logs are supplied - this is the traditional logset model. Media placement follows the supplied logset diagram.
How close can a mantel or shelf be?
Keep a mantel at least 12" above the opening and any shelf at least 9" above the top of the unit; the ceiling needs 36". All facing material around the fireplace must be non-combustible - it can run past 250°F in operation.
What’s included, what’s required, and what’s optional?
-
Included in the box: the burner with five ceramic-fibre logs, and the safety screen barrier (it must be installed).
-
Required to complete the installation, purchased separately: nothing — this is a ventless outdoor fireplace, so there is no flue, vent pipe or chimney to buy.
-
Optional: a drain pan, alternate media, and a remote.
Is it safe to buy a Montigo fireplace online? What about warranty?
Yes. The Torch Guys is 1 of only 3 authorized Montigo e-commerce dealers in the United States, so Montigo's residential fireplace warranty applies to your purchase, and we file warranty claims on your behalf if anything ever goes wrong. Want to talk it through first? Call (410) 324-6322.
Downloads
